Questions and Answers

Honda Accord Glove Box Removal Q. One of your questions that someone asked about changing the 1999 Honda Accord Cabin Air Filter was not detailed enough about how to get the glove box out. On my 2000 Honda Accord I could not figure out hot to get the door off of the glove box to get the glove box out to change the two filters. Could you please help?

I would also like to know if you know how to change the bulb in the dash board clock on the 2000 Honda Accord?

Thank You for your time!

A. Here is the procedure for removing the glove box. I wonder, does anyone actually put gloves in the glove box? Anyway, here you go!

1. Remove these items:

• Dashboard center lower cover.
• Passenger's dashboard lower cover.

2. Remove the screws from bottom of the glove box.

3. Wrap a flat-tip screwdriver with protective tape, and apply protective tape around the related parts, to prevent damage. Insert a flat-tip screwdriver in the notch (A) of the cap (B), and release the hooks (C) by prying up the cap (D).
4. Remove the screws.

5. Release the hooks (A), then pull down on the striker (B) to remove the glove box. Disconnect the glove box light connector (C).
6. Install in the reverse order of removal, and make sure the glove box light connector is plugged in properly.

To replace the clock illumination bulb, remove the clock from the center panel. Detach the clips, and release the retaining tabs (A), then pull the clock out. Disconnect the clock connector (B) and hazard warning switch connector (C).