By Alvie Rodgers C.E.T.

Ignition Switch Identification

This picture is looking down the top of the steering column. Several important items can be seen:

1. Here is the ignition switch assembly.
2. Here is the dimmer switch assembly.
3. Two bolts holding the column at the floor.
4. Here is where the two bolts holding the column that go up into the underside of the dash.
5. The white cable is the drive gear location control cable to tell you what gear you are in.
6. This the connection junction box under dash. There's a bolt that holds the two pieces together. Remove bolt and separate the two pieces to allow removal of steering column.

~~~~~~~~~~

Drive Gear Cable And Drive Gear Identification Cable Removal Procedure:

Located on the right hand side of the Steering Column, just below the Bowl is the Gear Shift Mechanism and the Drive Gear Identification cable.

The Picture above shows how to remove.

First, with a flat blade screwdriver, placed under the end of the Gear Shift Cable, pry upward and unsnap the cable from the Gear shift lever.

Then unsnap the cable protection and lock sleeve on the gear shift cable so the cable can be released. Then slide out the slot.

Unhook the Gear Identification cable and slide it through the same slot. Looks like fish line.

Back       Next
Start