Disassembly: Transaxle Support Assembly (Bracket)

1. Remove the negative battery cable.
2. Remove the air intake duct.
3. Remove the Throttle Valve (TV) cable.
4. Remove the power brake booster line and hose.
5. Install engine support fixture J 28467-A. Raise the engine just enough to take the pressure off the engine mounts.
6. Raise and support the vehicle with the jack and jack stands.
7. Remove the engine mount strut.
8. Remove the left front wheel and tire assembly.
9. Remove the left splash shield.
10. Remove the cross member.
11. Remove the left front ABS wheel speed sensor connector and harness from the suspension support.
12. Remove the left front ball joint.
13. Remove the left stabilizer bushing nuts.
14. Remove the stabilizer shaft from the left lower control arm.
15. Remove the left suspension support.
16. Remove the left side drive axle from the transaxle.
17. Remove the transaxle cooler pipes and plug to prevent leakage.
18. Remove the P/S lines from the P/S gear and plug it to prevent leakage.
19. Remove the transaxle mount to body bolts.
20. Remove the pipe expansion bolt from the transaxle support assembly.
21. Remove the lower engine/transaxle assembly just enough to be able to remove the transaxle support assembly and mount assembly.
22. Remove the transaxle mount from the transaxle support assembly.
23. Remove the transaxle support assembly fasteners.
24. Remove the transaxle support assembly.